Low Slope Waterproo fing
The Aluminum Base Plate can be installed over concrete, metal roof with insulation or steel structures. The Aluminum Base Plate can be used as part of our permanent lifeline system,Total Grip, or as a single anchor point.
R-Panel/Trapezoidal Roof
The Steel Bent Plate is installed on an r-panel, or a trapezoidal roof. The Steel Bent Plate is a stamped manufactured plate that is designed to be used as part of our permanent lifeline system,Total Grip, or as a single anchor point.
Standing Seam Roof
The Extruded Base Plate 550/700 is install over standing seam roofs, round or double fold ribs, or trapezoidal roofs depending on the rib distance. The Extruded Base Plate is an extruded aluminum plate is designed to be used as part of our permanent lifeline system,Total Grip, or as a single anchor point.
TOTAL GRIP HLL SYSTEM
The Total Grip HLL System is a complete solution that can be adapted to any work area. Our system can be installed directly to the roof or to the structure if necessary, depending on the calculation obtained through our HLL Assistant calculation tool.
Our selection of bases allows the Total Grip system to be used on any type of structure; concrete, metal, roof with insulation, trapezoidal roof, standing seam roof, round or double-folded and many others.
NON-INVASIVE INSTALLATION
Our HLL System has been designed with the integrity of the roof structure in mind. Our installation components are considered non-invasive with a limited number of components. It employs aluminum rivets on trapezoidal roofs and aluminum roof clamps on standing seam roof, round or double fold. Only the installation of our Aluminum Base Plate requires a small hole of 1 5/8″ to install the required toggle anchor.
UNINTERRUPTED CONNECTION
Another key distinction of the Total Grip system is our simply designed yet convenient and safe Roof/Wall slider, which allows users to move smoothly and without interruptions throughout the entire installed horizontal lifeline, passing through the cable guides without needing to disconnect from the line.
MODULAR DESIGN
Due to our sophisticated design and modular configuration, our system can be installed using posts with integrated kinetic absorber between a tensioner end and a swage end, or with rigid posts between a line dampener and tensioner end.
EASY INSPECTION AND REPLACEMENT
A limited number of required components makes the Total Grip lifeline system easy to inspect. If a fall occurs and the line is impacted, only the kinetic absorber or line dampener need to be replaced, and the other components can continue to be used as long as the line is re-tensioned. This makes for a quick and cost-effective replacement process with no effect on the roof structure.